networkview rpc functions are deprecated

#Networkview rpc functions are deprecated password

#Networkview rpc functions are deprecated password

When Automated Mode is enabled, all RPC password security functions are disabled, and users are able to access System Level command functions (including the configuration menus) and control circuits without entering a password.When Automated Mode is enabled, the Web Browser Interface can still be used to invoke switching and reboot commands. Note that although Automated Mode can be enabled using either the Web Browser Interface or Text Interface, Automated Mode is designed primarily for users who wish to send ASCII commands to the RPC without operator intervention, and therefore does not specifically apply to the Web Browser Interface. When Automated Mode is enabled, the /ON, /OFF, /BOOT, and /X commands are executed without a 'Sure?' confirmation prompt and without command response messages the only reply to these commands is the 'RPC>' prompt, which is displayed when the command is complete.

Automated Mode is designed to allow the RPC to be controlled by a device which can generate commands to control power switching functions without human intervention. The Automated Mode Operation The Automated Mode allows the RPC to execute switching commands, without displaying menus or generating response messages. When you disconnect using the Log Out button or /X command, this ensures that the RPC has completely exited from command mode, and is not waiting for the inactivity timeout period to elapse before allowing additional connections. Logging Out of Command Mode When you have finished communicating with the RPC, it is important to always disconnect using either the 'Log Out' button (Web Browser Interface) or /X command (Text Interface), rather than simply closing your browser window or communications program. For example, to Boot all circuits, enter the following: /BO * 6.3. All Circuits: To apply a command to all circuits, enter an asterisk in place of the name or number. For example, to switch circuits 1 through 3 On, enter the following: /ON 1:3 4. Range of Circuits: To apply a command to a range of RPC circuits, enter the number for the circuits that mark the beginning and end of the range, separated by a colon. For example to switch circuits 1, 3, and 4 Off, enter the following: /OFF 1+3+4 2. Several Circuits: To apply a switching command to several circuits, enter the numbers or names for the circuits, separated by a 'plus sign' (+). Note: When switching operations are initiated, Boot/Sequence Delay times will be applied as described in Section 5.3.3.2. Applying Commands to Several Circuits - Text Interface As described below, switching commands can be applied to only one switched DC circuit, or to an assortment of circuits. RPC-4850-8N Remote Power Controller - User’s Guide 6.2.3.